Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 74)

Using PanelBuilder
Chapter 3
3-38
Buttons and AutoĆRepeat
Three groups of buttons can have auto-repeat settings assigned. When
auto-repeat settings are changed from the default, the application will not
be compatible with version 1 firmware. For more information on version
control see Chapter 2, Installing Panel Builder.
Group 1 objects must be individually configured for auto-repeat when
each object is created. Group 1 objects include:
Increment and Decrement Buttons
Numeric Cursor Point Raise/Lower Function Keys
Set the Auto-Repeat Rate (per Sec.), Auto-Repeat Start Delay, and Amount
per Increment (for Increment buttons) or Amount per Decrement (for
Decrement buttons) under Address in the Object menu.
Group 2 objects are configured for auto-repeat as a group. Group 2 objects
include:
Screen List Selector Up/Down Cursor Buttons
Control List Selector Up/Down Cursor Buttons
Control List Selector with Enter Up/Down Cursor Buttons
Cursor Point Up/Down/Left/Right Function keys
Alarm Window Up/Down Cursor Buttons/Keys
Alarm History Screen Up/Down Cursor Buttons/Keys
Alarm Status Screen Line Up/Down Cursor Buttons/Keys
Cursor List Up/Down PgUp/PgDown Cursor Buttons
Set the Cursor Auto-Repeat Rate (per Sec.) and the Cursor Auto-Repeat
Start Delay under Options in the File menu. For group 2 objects, the
Amount per Increment is fixed at one.
Group 3 objects have a preset for auto-repeat which is not configurable.
Group 3 consist of the following objects in the Configuration Mode Menu
and the windows accessed from it:
Main Menu: Up/Down Cursor Buttons/Keys
Serial Port window: Change Data Button/Key
Serial Port window: Up/Down Cursor Buttons/Keys