6ć11 – Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL User Manual
Page 185
File Operations
Chapter 6
6-11
Table 6.B
Communication Settings
Available on PanelView Terminals
Baud Rate
300
600
1200
2400
4800
*9600
19200
Parity Type
odd
even
*none
Data Bits
7
*8
Stop Bits
*1
2
Handshake Type
*Hardware
Software
Auto Line Feed
*Off
On
Auto Form Feed
*Off
On
*default settings
5.
Press Save & Exit, and you return to the Configuration menu.
Setting Upload/Download Communications on the PanelBuilder
Computer
For uploading and downloading, the communication settings on the
PanelBuilder computer must match those of the PanelView terminal. The
default settings of the PanelBuilder software (indicated by * in Table 6.C)
are the same as the default settings of the PanelView terminal (indicated
by * in Table 6.B).
You can change the communication settings for either of the COM ports if
you wish. Also, you can configure one of the COM ports for
upload/download, and the other for printing (see Step 6 of Printing Reports
described earlier in this chapter).
1.
From PanelBuilder’s Main menu, choose Transfer.
2.
In the Transfer menu, choose Download to PanelView Terminal
(RS-232).
3.
Select a file and press Enter. The Select File window opens.
4.
Choose Configure Port from the Select File menu. The available port
and communication settings are as follows:
Table 6.C
Upload/Download Communication Settings Available in PanelBuilder
Port
COM1
COM2
Baud Rate
300
600
1200
2400
4800
*9600
19200
Parity Type
odd
even
*none
Data Bits
7
*8
Stop Bits
*1
2
*default settings