Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 198)

File Operations
Chapter 6
6-24
Figure 6.23
PassĆThrough Download to PanelView Menu
22559
Pass-Through Download To PanelView (DH+ and Remote I/O)
Select Application File 0
Application File Comment
Select Directory C: \PDS
Download Application File
PanelView Location Data
Rack
Group
Module (High/Low Byte)
PLC Type PLC-5/15 integral
PLC DH+ Address (0-77)
Local Bridge Address Not Used
Remote Bridge Address Not Used
Programming Terminal Configuration
Quit
ATTENTION: Incorrect address selection could corrupt data in
a non-PanelView device. Verify that the address entered is
correct for your network.
If there are no application files in the selected directory, choose Select
Directory to change to the directory for the file you want to download.
If there are application files in the current directory, the Select Application
File field will display the name of the last file edited in this session; if
none, the last file name entered or selected; if none, the first application
file in the selected directory. The Application File Comment and the
PanelView Location Data for that file will be automatically copied to the
window.
You have the option at this point of changing some of the PanelView
Location Data. The PLC DH+ Address and the Local and Remote Bridge
Addresses can be configured at the time of the download. The changes will
apply only to this download operation, and will not be saved with the
selected application file, or replace the parameters configured in the file, if
any.
IMPORTANT: Both the local and remote bridge addresses must be
defined or both must be set to “Not Used” in order to download the
application file.