Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 170)

Creating a Sample Application File
Chapter 5
5-56
B O 1 2/0 thru 2/15 with the BCD Data Type
B O 1 3/0 thru 3/15 with the BCD Data Type
B O 1 4/0 thru 4/15 with the BCD Data Type
6. Choose Exit from the Object menu and choose Exit and Save Object.
You are returned to the Screen menu.
You have now defined two Numeric Data Displays. To add the other three,
repeat the above steps using the correct position and address for each one.
Add the “Return To Previous Screen” Button
The “Return To Previous Screen” button that you created on Screen 2 is
identical to the one you need for this screen. Rather than recreating the
button on this screen, you can call up Screen 2 and memorize the existing
button. Here’s how to do it:
1. You should be at the Screen menu. Choose Exit then Exit and Save
Screen. You are returned to the Screens menu of the File menu.
2. Choose Select Screen and choose 2 CONVEYOR.
Screen 2 is displayed and the Screen menu appears across the top of
the monitor.
3. Choose Memorize from the Screen menu, move the cursor to the
“Return To Previous Screen” button in the top right corner of the
screen, and press Enter.
The button is now memorized, ready to be recalled in Screen 3.
4. Choose Exit then Don’t save, just Exit and finally Yes. This returns
you to the File menu.
5. Choose Select Screen and choose 3 PUMP. Screen 3 is again
displayed.