DAVIS FMS 3.9.3 DriveRight (8186) - Manual (Page 153)

DriveRight FMS Help
3. Set GPS Logging to On, Off, or DriveRight Speed Only.
o Select On to enable GPS logging.
o Select Off to disable GPS logging.
o Select DriveRight Speed Only to log the DriveRight speed without the GPS
coordinates. No GPS unit is required to enable this option.
4. Enter the desired logging interval and indicate a time unit of either seconds (Sec) or
minutes (Min). Logging Hours indicates how much data can be stored at the selected interval.
5. Click Set to save the changes or click Cancel to exit without changing the settings
Back to DriveRight Menu | DriveRight Settings
Home | Getting Started | Quick Reference | Menu Commands | Troubleshooting
DriveRight Settings: Verify DriveRight Calibration
The Calibrate DriveRight dialog box allows you to verify DriveRight calibration settings.
 The Calibration Setting dialog box shows two installation methods. VSS (vehicle speed
sensor) installation and Reed Switch.
To verify the DriveRight console calibration:
1. Click on DriveRight Settings from the DriveRight Menu.
2. Select Verify DriveRight Calibration from the drop-down menu. A DriveRight
Calibration Message dialog box is displayed.
3. Click OK, Set or Cancel to continue, depending on the displayed message. The
Calibrate DriveRight dialog box is displayed.
141