Yokogawa GC8000 Process Gas Chromatograph - Manual (Page 41)

<3. Overview Window>
3-13
IM 11B06C01-01E
3.6 Selecting Analyzer
To display any window other than the Overview window or perform operations for a specific
analyzer, you need to first specify the ID number of that analyzer.
This section describes how to specify the analyzer ID.
There are two ways of specifying the analyzer ID: a method specifying it using a command or a
button, and that of specifying it from the Analyzer Status window.
l Method of specifying analyzer ID using a command or a button
(1) Click on the Analyzer ID command in the Display Setting menu.
• You can also conduct this operation by clicking the button on the toolbar.
The following message appears asking whether you want to continue operation.
(2) Click the Yes button.
A dialog box for entering an analyzer ID appears.
(3) Enter the analyzer ID number.
(4) Click the OK button.
The specified analyzer ID is set and displayed in the analyzer ID display section on the
toolbar.
l Method of specifying analyzer ID from the Analyzer Status window
On the Analyzer Status window, double click on the inside of the ID number frame of the analyzer
you wish to specify.
The specified analyzer ID is set and displayed in the analyzer ID display section on the toolbar.
TIP
When the selected analyzer’s ID has been set, all windows other than the Overview window will be erased
because the corresponding analyzer is changed. Also, the database of the newly set analyzer is uploaded to
memory; this takes some time.
5th Edition : Nov. 16, 2011-00