Yokogawa Integral Oxygen Analyzer ZR202 User Manual
User's manual
Table of contents
Document Outline
- ZR202G
- Introduction
- r For the safe use of this equipment
- r NOTICE
- 1. Overview
- Contents
- 2. Specifications
- 3. Installation
- 3.1 Installation of High-temperature Humidity Analyzer
- 3.2 Installation of ZA8F Flow Setting Unit
- 3.3 Installation of ZR20H Automatic Calibration Unit
- 3.4 Installation of the Calibration-gas Unit Case (E7044KF)
- 3.5 Insulation Resistance Test
- 3.6 Installation of the High Temperature Humidity Analyzer (with pressure compensation)
- 4. Piping
- 5. Wiring
- 6. Components
- 7. Startup
- 8. Detailed Data Setting
- 9. Calibration
- 10. Other Functions
- 10.1 Detailed Display
- 10.1.1 Oxygen Concentration
- 10.1.2 Humidity
- 10.1.3 Mixing Ratio
- 10.1.4 Relative Humidity
- 10.1.5 Dew Point
- 10.1.6 Cell Temperature
- 10.1.7 Process Gas Temperature
- 10.1.8 Cold Junction Temperature
- 10.1.9 Cell Voltage
- 10.1.10 Thermocouple Voltage
- 10.1.11 Cold Junction Voltage
- 10.1.12 Current Output
- 10.1.13 Response Time
- 10.1.14 Internal Resistance of Cell
- 10.1.15 Robustness of a Cell
- 10.1.16 Heater On-Time Ratio
- 10.1.17 Oxygen Concentration (with time constant), Humidity (with time constant), and Mixing Ratio (with time constant)
- 10.1.18 Maximum Oxygen Concentration, Humidity, and Mixing Ratio
- 10.1.19 Minimum Oxygen Concentration, Humidity, and Mixing Ratio
- 10.1.20 Average Oxygen Concentration, and Mixing Ratio
- 10.1.21 Span-gas and Zero-gas Correction Ratios
- 10.1.22 History of Calibration Time
- 10.1.23 Time
- 10.1.24 Software Revision
- 10.2 Operational Data Initialization
- 10.3 Initialization Procedure
- 10.4 Reset
- 10.5 Handling of the ZO21S Standard Gas Unit
- 10.6 Methods of Operating Valves in the ZA8F Flow Setting Unit
- 10.1 Detailed Display
- 11. Inspection and Maintenance
- 12. Troubleshooting
- CMPL
- Revision Record