Yokogawa GC8000 Process Gas Chromatograph - Manual (Page 124)

<5. Display and Operations while Connected to GC1000 Mark II>
5-14
IM 11B06C01-01E
n Types of Operation Mode and Changing Procedure
l Operation mode types and current status display
There are three types of operation modes as follows:
Status Button Description
Run Runs operation.
Pause Pauses operation.
Stop Activates the queued operation status.
The condition of each button indicates the current status of the operation mode.
(Example) In the case of "Run" mode
Button Status Description
"Run" mode is running.
A request for change of "Run" mode can be made.
"Run" mode is reserved.
A request for change to "Run" mode cannot be made.
l Changing the operation mode
To change the operation mode, click the button of the operation mode you wish to change to. The
operable button(s) differs depending on current conditions. The operable button(s) is displayed in
black; any status(es) not acceptable is grayed out.
There is also a “Cancel Command” button
. This is a command-dedicated button that cancels
the queued operation mode.
n Types of Measurement Statuses and Changing Procedure
l Types of measurement statuses
There are four types of measurement statuses as follows:
Measurement Status Button Description
Stream Sequence Runs a stream sequence.
Stream (Continuous) Measures a specified steam continuously.
Stream (One) Measures a specified steam only once.
Calibration/Validation Enables calibration or verification.
The current condition of the measurement status is displayed in the lower half of the Operation
Status Display bar, and each button is command dedicated.
5th Edition : Nov. 16, 2011-00