Teledyne LeCroy WaveExpert 100H Operators Manual - Manual (Page 99)

Wave Expert
WE-OM-E Rev A
97
.
B. Then touch the Show last trace checkbox if you want the last trace displayed.
C. Touch inside the Saturation data entry field and enter a whole number integer, using
the pop-up numeric keypad.
D. Touch inside the Persistence time data entry field and make a selection from the
pop-up menu.
4. If you selected Per Trace, for each input channel touch its tab, then make selections of
mode, saturation level, persistence time, and last trace display in the same way as for All
Locked.
5. To create a 3-dimensional view, touch the 3d button . Then
A. Touch inside the Saturation data entry field and enter a whole number integer, using
the pop-up numeric keypad.
B. Touch inside the Persistence time data entry field and make a selection from the
pop-up menu.
C. Under "3D settings," touch inside the Quality field and select an image quality from the
pop-up menu: wire frame, solid, or shaded.
D. For each axis, touch inside the data entry field and enter a value from -90° to +90°.
6. To turn off persistence for an individual channel, touch the left-most persistence mode
button:
.
To turn off persistence for all channels, press the front panel A NALOG P ERSIST button. This
button toggles Analog Persistence on and off.
Screen Saver
The Windows screen saver is activated in the same way as for any PC.
1. Minimize the instrument display by touching File in the menu bar, then Minimize in the
drop-down menu.
2. Touch Start down in the task bar.
3. Touch Settings in the pop-up menu.
4. Touch Control Panel.
5. Touch Display.
6. Touch the Screen Saver tab.