Teledyne LeCroy WaveExpert 100H Operators Manual - Manual (Page 151)

Wave Expert
WE-OM-E Rev A
149
3. Touch the Show All button to display Help Markers for every parameter
being measured on the displayed waveform (C2 in the examples above).
4. Touch a P1 to Px tab for any parameter listed; it doesn't matter which. Touch
inside the Help Markers field and select Simple The Simple selection produces cursors
and Measure Gate gate posts. The gate posts are independently placeable for each
parameter. or Detailed The Detailed selection produces cursors, Measure Gate gate
posts, a label identifying the parameter being measured, and a level indicator and
hysteresis band for "at level" parameters..
Note: The choice of Simple or Detailed is applied to all parameters at the same time. That is, if you choose Simple markers
for one parameter, all parameters will be displayed in this mode.
5. Touch the Always On checkbox if you want to continuously display Help Markers for this
parameter.
To Turn Off Help Markers
1. Touch the Clear All button to turn off Help Markers for all parameters.
2. To turn off Help Markers for individual parameters, touch the Px tab for the parameter in
question. Then uncheck the Always On checkbox. When you close this dialog, the Help
Markers for this parameter will no longer be displayed.
To Customize a Parameter
From the Measure Dialog
1. Touch the My Measure button in the "Measure" dialog. The dialog presents you with a
panel of eight preset parameters.
2. For each parameter, touch the On check box to enable the parameter listed.
3. If you want to change the parameter listed, or a measurement characteristic, touch the
parameter button (P1 for example) alongside the check box. A pop-up menu of
parameters categorized by type appears. To display parameter icons only, touch the icon
button at the bottom of the menu. To display the icons in list form, along with an
explanation of each parameter, touch the list button . Use the Up/Down buttons to
scroll through the list of icons.