Teledyne LeCroy WaveExpert 100H Operators Manual - Manual (Page 342)

Operator’s Manual
340
WE-OM-E Rev A
CDR-E135
Description
The CDR-E135 clock recovery module is designed to plug into any available slot of a LeCroy
WaveExpert mainframe. The module supplies a recovered clock at the data rate of the applied
single-ended or differential data signal. The module has four K-type (2.95 mm) female connectors,
two signal inputs for Data+ and Data-, and two monitor outputs for Data+ and Data-. The monitor
output signals are DC coupled to the input signals, using internal resistive dividers, and must be
properly terminated when not in use. The single-ended recovered CLK OUT signal is available at a
female SMA connector.
Features
• Wide Frequency Range: 622 Mb/s to 13.5 Gb/s (with option 001)
• High Input Sensitivity
• Very
Low Jitter
• Fast Rise/Fall Times
• Differential or Single-ended Inputs
• Monitor
Outputs
• Plugs into any available slot in the WaveExpert mainframe
Front of CDR-E135
Front of Module
Outputs: K-type (2.92 mm) female connectors for Data+, Data-, Monitor+, Monitor-. Female SMA
connector for recovered clock out.
CAUTION: ESD Sensitive
The CDR-E135 inputs are sensitive to Electrostatic Discharge (ESD). To avoid causing
damage to the module, always follow anti-static procedures (wear wrist strap, etc.) when
making connections.