Teledyne LeCroy WaveExpert 100H Operators Manual - Manual (Page 37)

Wave Expert
WE-OM-E Rev A
35
WARNING The WARNING sign indicates a potential hazard. It calls attention to a procedure,
practice or condition which, if not followed, could possibly cause bodily injury or death.
If a WARNING is indicated, do not proceed until its conditions are fully understood and
met.
CAT I Installation (Overvoltage) Category rating per EN 61010-1 safety standard and is
applicable for the oscilloscope front panel measuring terminals. CAT I rated terminals
must only be connected to source circuits in which measures are taken to limit
transient voltages to an appropriately low level.
Operating Environment
The scope is intended for indoor use and should be
operated in a clean, dry environment. Before using
this product, ensure that its operating environment will
be maintained within these parameters:
Temperature: 5 to 40 °C
Humidity: Maximum relative humidity 80% for
temperatures up to 31 °C decreasing linearly to 50%
relative humidity at 40 °C
Note: Direct sunlight, radiators, and other heat sources should be
taken into account when assessing the ambient temperature.
WARNING
The scope must not be operated in
explosive, dusty, or wet atmospheres.
CAUTION
Protect the scope’s display touch screen
from excessive impacts with foreign
objects.
CAUTION
Do not exceed the maximum specified
front panel terminal voltage levels. Refer to
Specifications for more details.
CAUTION
ESD sensitive: The sampling modules
inputs are highly static sensitive. A
grounding strap must be worn at all times
when handling the modules.