Teledyne LeCroy WaveExpert 100H Operators Manual User Manual

Page 66

Operator’s Manual

WE-OM-E Rev A

VERTICAL SETTINGS AND CHANNEL CONTROLS

Adjusting Sensitivity and Position

To Adjust Sensitivity

1. Press the appropriate channel push button, for example

to turn on channel 1. Or

touch Vertical in the menu bar, then Channel 1 in the drop-down menu.

2. Touch

inside

the

Trace On checkbox to display the trace.

3. Turn the volts per division knob for the selected channel.

Or you can touch inside the Volts/Div field and type in a value using the pop-up keypad, or
use the up/down arrows.

4. The voltage that you set is displayed in the trace descriptor label and in the Volts/Div field.

To Adjust the Waveform's Position

Turn the vertical offset adjust knob directly above the channel button whose waveform you want to
move vertically.

Or you can touch inside the Offset field and type in a value on the pop-up keypad. To set the
vertical offset to zero, touch the Zero Offset button directly below the Offset field.