Teledyne LeCroy WaveExpert 100H Operators Manual - Manual (Page 41)

Wave Expert
WE-OM-E Rev A
39
Calibration
The recommended calibration interval is one year. Calibration should be performed by qualified
personnel only.
Cleaning
Clean only the exterior of the scope, using a
damp, soft cloth. Do not use chemicals or
abrasive elements. Under no circumstances
allow moisture to penetrate the scope. To
avoid electrical shock, unplug the power cord
from the AC outlet before cleaning.
WARNING
Electrical Shock Hazard!
No operator serviceable parts inside. Do not
remove covers.
Refer servicing to qualified personnel.
Abnormal Conditions
Operate the scope only as intended by the
manufacturer.
If you suspect the scope’s protection has
been impaired, disconnect the power cord
and secure the scope against any unintended
operation.
The scope’s protection is likely to be impaired
if, for example, the scope shows visible
damage or has been subjected to severe
transport stresses.
Proper use of the scope depends on careful
reading of all instructions and labels.
WARNING
Any use of the scope in a manner not specified by
the manufacturer may impair the scope’s safety
protection. The scope and related accessories
should not be directly connected to human subjects
or used for patient monitoring.