Teledyne LeCroy WaveExpert 100H Operators Manual - Manual (Page 49)

Wave Expert
WE-OM-E Rev A
47
Position
Adjusts the vertical position of the selected zoom trace on the display.
Zoom
Adjusts the vertical zoom (magnification factor) of the selected zoom trace on the
display.
Wavepilot
Control
Buttons:
Reset Resets the zoom factors.
Math Provides access to the Math setup dialog.
Measure Provides access to the Measure setup dialog.
Analysis
Provides access to the Analysis setup dialogs.
Quick Set
Buttons:
Scope
Takes the scope out of TDR or Eye mode.
TDR
Provides access to the TDR setup dialog and sets the scope to TDR mode.
Eye
Provides access to the Eye mode setup dialog and sets the scope to eye mode.
Special
Features
Buttons:
Auto Setup Automatically sets the scope's horizontal timebase (acquisition system), vertical
gain and offset, as well as trigger conditions, to display a wide variety of signals.
Cursors The center button calls up the "Standard Cursors" setup dialog. The other two
buttons control the placement of the cursors on your waveform.
Default Setup Sets the scope's horizontal timebase (acquisition system), vertical gain and offset,
and trigger conditions to default settings.
Help Displays the on-line Help manual. You can choose to receive control help, or to
search for the information you need using the Table of Contents and Index.
Control Help displays help for a particular button, menu item, data field, etc.
contained in the dialogs.
Save/Recall Calls up the dialogs for saving and recalling waveforms and setups, and for disk
utilities.
Analog
Persist
Provides a three dimensional view of the signal: time, voltage, and a third
dimension related to the frequency of occurrence, as shown by a color-graded