Teledyne LeCroy WaveExpert 100H Operators Manual - Manual (Page 55)

Wave Expert
WE-OM-E Rev A
53
Software
Checking the Scope Status
To find out the scope's software and hardware configuration, including software version and
installed options, proceed as follows:
1. In the menu bar, touch .
2. Touch the tab.
You can find information related to hard drive memory, etc. as follows:
1. Minimize the instrument application by touching , then selecting Minimize in the
drop-down menu.
2. Touch the Start taskbar button and, per usual Windows® operation, open Windows
Explorer.
Default Settings
You can reset the scope to default settings by simply pressing the D EFAULT S ETUP push button on
the front panel. This feature turns on Channel1 and Channel 2, with no processing enabled.
Other default settings are as follows:
Vertical Timebase Trigger
100 mV/div 1.00 ns/div Prescale
0 V offset 1.0 KS, -12 ns delay
Sequential acquisition Auto trigger mode
Adding a New Option
To add a software option you need a key code to enable the option. Call LeCroy Customer Support
to place an order and receive the code.
To add the software option do the following:
1. In the menu bar, touch .
2. In the dialog area, touch the tab.
3. Touch .
4. Use the pop-up keyboard to type the key code. Touch O.K. on the keyboard to enter the