IAI America S-SEL-E - Manual (Page 80)

Page 75
19-1 Servo Parameter Mode (18-1. F1)
F1- Goes to next axis no. (+1). Axis name will also be
changed. (P76. 19-1-1)
F2- Goes backward -1 (P76. 19-1-2)
F3- Clears data for data entry
F4- Direct number input
Return- (Inc[<=]) adds +1
F1 F2 F3 F4
Para Axis 1[1] Srvo
1. Numerator
Inc [ < = ]
1
Axis + Dec Clr Wrt
Chapter 2. Operation
18-3 System parameter additional selections (Step 18-2. F4)
F1- (Sio: Serial I/O RS232C) System Sio parameter
mode (P78. 20-4)
F2- (Cir: Circle) System path/circular parameter mode
(P78. 20-5)
F4- (Etc) Returns to system parameter mode. (P75. 18-
2)
Para System
Sio Cir Etc
F1 F2 F3 F4
18-2 System Parameter Mode (Step 18. F2)
F1- System program parameter mode
F2- System point parameter mode
F3- System servo parameter mode
F4- Additional selection mode (P75. 18-3)
Para System
Prog Pos Srvo Etc
F1 F2 F3 F4
Para Axis
Srvo Home Motr Name
F1 F2 F3 F4
18-1 Parameter Mode for each axis (Step 18. F1)
F1- Servo parameter mode for each axis (P75.19-1)
F2- Home parameter mode for each axis (P76.19-2),
axis activation mode
F3- Motor parameter mode for each axis (P76. 19-3)
F4- Axis name parameter mode for each axis (P77. 19-4)
18. Parameter Mode (Step 3, F3)
F1- Parameter mode for each axis (P75. 18-1)
F2- System parameter mode (P75. 18-2) (P77.20)
Para
Axis Sys
F1 F2 F3 F4
3. Parameter Mode
*Important* Please contact our technical service department if parameters need to be changed for your system.