IAI America S-SEL-E - Manual (Page 74)

Page 69
Mdi - 1 No 8[8] - 8
500.000 600.000
700.000 600.000
Wrt Can Clr Etc
8-3 Use the F1 key (Wrt) to save data for up to 8 axes.
However, do not write data while a program is running
(cannot guarantee data will be saved).
F1- Wrt: Write
F2 - Can: Cancel
F3- Clr: Clear
F1 F2 F3 F4
Step - 1 No 1[1] - 8
1.234 12.345
123.456 1234.567
Inc Dec Go JVel
F1 F2 F3 F4
10. Point Step Mode (Go back to the display in step number 5,
then press F3.)
F1- Position No. +1
F2- Position No. -1
F3- Move to designated position
F4- Designate velocity
Chapter 2. Operation
Clear All Position
Clr
F1 F2 F3 F4
Posi Shift
From St. 1 Ed.
To St. Ed.
Clr
11-2 Position Clear Mode (Go back to the display in Step
6-2. Then, press F3.)
F3- Clears all position numbers.
F1- Execute
11-1 Position Shift (Move) Mode (6-2. F1 key)
Moves the specified multiple position data. Input the
beginning and the ending position No. of the original
position (From), then input the beginning and the end-
ing position No. of the target position (To).
*Position Copy Mode (6-2. F2 key) for duplication can
be operated in the same manner.
9. Position Data Velocity and Acceleration Setting (Step 8.
F3)
(Velocity: 3-digits, Acceleration 9.99, 2-digits after deci-
mal point.)
F1 F2 F3 F4
Mdi - 1 No. 1[1] - 8
1.234
12.345
Vel [300] Acc[0.99]
Wrt Axis Clr
F1 F2 F3 F4