IAI America S-SEL-E - Manual (Page 240)

Page 235
Chapter 5. Option
1) When the power is turned ON,
The SAVE LOAD lamp blinks 5 times to indicate the power has been turned ON. During this time, any button
operations cannot be performed.
2) SAVE
"SAVE" takes up data from the Super SEL Controller to the Flash Memory Card.
Start by pressing the SAVE button. When the data is being saved, normally the SAVE lamp blinks. When data is
already written in the Memory Card, the existing data will be deleted and the data sent from the controller will be
written in.Data can be saved while an application program in the controller is running.
3) LOAD
"LOAD" sends data to the Super SEL Controller from the Flash Memory Card.
Start loading by pressing the LOAD Button. When the data is being loaded, normally the LOAD lamp blinks. When
there is no data in the Flash Memory Card, nothing will be loaded (If data with nothing written is sent to the controller, all
data in the controller will be deleted). Data cannot be loaded while an application program in the controller is running.