IAI America S-SEL-E - Manual (Page 119)

Page 114
7. Axis Designation
There are two ways to designate the axes to be used: axis number and axis pattern.
(1) Axis number and notation
With the Super SEL controller, multiple axes are indicated as shown in the table, but it is possible to change the figures
using the parameters.
Chapter 4. Programming
Axis No.
Default
Notation
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
The axis no. is used when designating one axis out of many axes.
Commands to designate Axis No. are:
BASE, PPUT, PGET