EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 70)

Issue
11.01.D
Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
60
9.3.8 How to Name a Clip
To name a clip, proceed as follows:
1. In the Clip screen, select the clip to name in one of the following ways:
a. Click on the clip with the stylus
b. Position the green arrows around the desired clip with the keyboard.
2. Type in the desired name with the keyboard. All characters available from the
keyboard are accepted, including blanks.
3. Press F1:
a. In CAM mode, only the camera where the cursor is located is named.
b. In CLIP mode, all cameras of the clip where the cursor is located are named.
The entry in the Name field is not cleared by pressing F1 and remains for future use.
Press < BACKSPACE> to delete the last character in the Name field, or press ESC to
clear the whole field.
Note
To be able to name/rename clips on a network machine, the
Clip edit by
Network parameter in the Operational Setup menu (P.5.1 F2) of the remote
machine must be set to “Yes”. If you are unable to name a network clip, please
check this setting on the remote machine.
9.3.9 How to Change the Primary Camera of a
Clip
To change the primary camera of a clip, proceed as follows:
1. In the Clip screen, move the cursor to the desired camera.
2. Press
F4 on the keyboard or click with the stylus on the corresponding area in the
Function bar.
→
This camera becomes the new primary camera.
→ If the selected camera is a secondary camera (indicated by “=”), it becomes the
primary camera and the previous primary camera becomes the secondary camera.