EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 134)

Issue
11.01.D
Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
124
Use with Split Audio
The simplest type of Split Audio edit that can be performed on an LSM is to make the
video and audio transitions at the beginning of the clip have different durations, such as a
12 Frame Video Mix with a 2 sec Audio cross fade.
The value of the
Audio effect duration parameter of the Operational Setup menu (p.3.1
F3) is only taken into account when the Advanced Audio Editing mode is enabled.
Otherwise, the audio effect duration is always locked to the video effect duration,
whatever the value of these parameters.
If the
Audio effect duration parameter in the setup is set to Lock to video, it will never
be possible to adjust independently the duration of the audio and video transitions. If you
want to adjust one of these transitions and the other one follows, please check the Audio
effect duration parameter in the setup, and make sure it is NOT set to Lock to Video.
11.16.5 Associations of Audio and Video
Transition Types
The following table shows the possible associations of audio and video transition effects
when the Audio effect duration parameter is not locked to the video in the Operational
Setup menu (p.3.1. F3):
Audio Effect Cut Mix Fade
from
Mute
Fade to
Mute
V Fade
to/from
Mute
Video Effect
Cut √ √
Mix √
Wipe Left -> Right √
Wipe Right -> Left √
Fade from color √
Fade to color √
V Fade (to/from Black) √