2 adding cut behavior, 13 other editing functions for playlists, 1 how to trim clips into a playlist – EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual User Manual
Page 123: Adding cut behavior, How to trim clips into a playlist
Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
Issue
11.01.D
113
11.12.2 Adding Cut Behavior
When adding a cut to a clip, Multicam will behave as follows:
•
The transition applied at the cut point is a cut (for both audio and video).
•
The speed of the cut elements is the same as the original element, even if it is
“Unknown”.
•
The stop and start modes of the cut elements are auto.
•
Any loop defined on the playlist that includes the original element conserves and
includes the cut elements.
•
Any tag defined and active on the original element at the cut point is recreated at the
short-in of the second cut element.
The adding cut is not possible in the following cases:
•
Within a video effect.
•
Within an audio effect beginning or finishing the original element.
11.13 Other Editing Functions for Playlists
11.13.1 How to Trim Clips into a Playlist
Every playlist element can be trimmed independently of all other instances of the same
clip number.
To trim clips into a playlist, proceed as follows:
1. Browse to the desired element in the playlist.
2. Re-mark a new Short IN or Short OUT.