EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 133)

Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
Issue
11.01.D
123
11.16.3 OSD Display in Advanced Audio Editing
In the Output Monitor display, additional information is also displayed when the split audio
mode is active:
The information displayed below the playback speed will display the audio delay/advance
or video delay/advance in frames depending on the editing action applied, or ‘no split’ if
no delay or advance is applied.
11.16.4 Default Duration for the Audio and Video
Transitions
General Use
It is possible to set a default value for the duration of the video and audio transitions in the
Setup Menu. Once this is defined, each time a clip is entered or inserted into a playlist,
transitions are applied with the default values.
The
Video effect duration parameter is available in the Operational Setup menu (p.3.1
F1), and ranges up to 20:00 secs.
The
Audio effect duration parameter is available in the Operational Setup menu (p.3.1
F3) and ranges up to 20:00 secs or takes the Lock to video value.