EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 107)

Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
Issue
11.01.D
97
11.6.3 How to Name the Current Element in the
Loaded Playlist
Note
Naming the current element of the loaded playlist will affect the original clips.
This function is only available when the playlist is the current one in Playlist Edit mode
(PLST EDIT) or Playlist Playout mode (PLST DIFF) on the EVS Remote Panel.
To name the current element in the loaded playlist from the VGA Playlist screen, proceed
as follows:
1. Press the
F10 key on the keyboard to open the VGA Playlist screen.
The loaded playlist is displayed and the current playlist element on the Remote Panel
is selected.
2. Type the desired name for the element on the keyboard.
It appears in the Name field at the bottom of the screen. Use to
delete the last character, or ESC to clear the entire field.
3. Press F1 to assign the new name to the current element.
The name for the current element will appear in the Name column of the selected
element.
11.7 Browsing Within a Playlist
11.7.1 Possible Browsing Methods
You can browse within a playlist in different ways:
• Browse quickly by jumping to the first field of each clip in the playlist:
For more information, see the section 11.7.3 ‘Browsing Quickly Through a Playlist’,
on page 98.
• Browse through the content of each clip in the playlist:
For more information, see the section 11.7.2 ‘Browsing Through a Playlist’, on page
97.
11.7.2 Browsing Through a Playlist
When you load a playlist, the default playlist mode allows you to scroll up and down
through all the playlist elements.