7 changing the audio or video effect duration, Introduction, How to change the video effect duration – EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual User Manual
Page 137: Changing the audio or video effect duration
Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
Issue
11.01.D
127
End On Cut
PL 17
Vx 2 – Ax 4
V
A
PL 18
Vx 4 – Ax 2
V
A
PL 16
Vx 2 – Ax 2
V
A
11.16.7 Changing the Audio or Video Effect
Duration
Introduction
When you change the video or audio effect duration, you extend or reduce the duration of
the video or audio transition:
•
In case of
Center on cut, the transition is extended/reduced on both sides. This
creates an audio delay or advance depending on whether you reduce or extend the
transition duration.
•
In case of
Start on cut, the transition is extended/reduced at its end point.
•
In case of
End on cut, the transition is extended/reduced at its start point.
How to Change the Video Effect Duration
To change the video effect duration, proceed as follows:
1. Enter the Playlist Edit mode.
2. Browse to the desired clip in the playlist.
3. Press SHIFT+A BASE (
A).
4. Press to highlight
V Fx Dur (C).
5. Move the lever to adjust the value.