22 rebooting the system from the lsm remote, Hard reboot, Soft reboot» from the keyboard – EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual User Manual
Page 30: Rebooting the system from the lsm remote

Issue
11.01.D
Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
20
4.1.22 Rebooting the System from the LSM
Remote
«Hard Reboot»
In the event that the system needs to be rebooted, the process can be accomplished from
the Remote Panel. Keep in mind that doing this while Multicam is running will of course
force the Multicam application to close abruptly, and up to 1 minute of the material being
recorded and not clipped could be lost.
To reboot, press the following key sequence,
Between step 3 and step 4, the
RECORD button will flash GREEN and the PAGE button
will flash RED. Hitting the
PAGE button will reboot the system. Hitting the RECORD
button will return to normal operation.
«Soft Reboot» from the keyboard
It is also possible to run a «soft reboot» which will exit the software and return the user to
the EVS Menu. Here, the software can be selected and entered again without having to
reboot the entire system. When running the following procedure, the system will
automatically save all recorded material (record trains, clips, playlists) upon exit.
Hit ALT+Q on the keyboard or press F6 from the main Menu, and confirm with
ENTER or
cancel with
ESC. You will exit the Multicam software and go back to the EVS Menu.