EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 160)

Issue
11.01.D
Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
150
12.6.3 How to Add a Clip to a Timeline
From the Remote Panel, you can add a clip at the end of a timeline created either with
IPEdit or with Multicam.
To add a clip to a timeline, proceed as follows:
1. Recall the requested timeline by selecting its page (SHIFT+Page+F
_ key) and bank
(SHIFT+F10) and the timeline position ( F_ key).
This becomes the current timeline.
2. Recall the clip to insert at the end of the timeline by selecting its page, bank and
position.
3. Press the ENTER key on the Remote Panel.
The clip is inserted at the end of the timeline.