EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 203)

Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
Issue
11.01.D
193
• If the Last Cue command refers to a TC that does not exist anymore, the key beeps
but the OSD still displays the number of the cue that you wanted to go to.
• Cue points can be marked across several blocks but the recall is limited to the
currently selected block.
Example:
o While recording on memory block 1, mark cue points 1, 2, and 3 on memory
block 1.
o Press TAKE to start recording on block 2 and mark cue points 1, 2, and 3.
o Press TAKE and select memory block 2. The Last Cue command scrolls through
the cue points of block 2.
o To go through cue points of another block, select that block first then press Last
Cue.
• On OSD, the first information, displayed in white, refers to the cue points on the
playing block while the second information, displayed in red, refers to the recording
block.
• Additionally, the play speed is displayed in % on the OSD.
18.5.5 For-A VFC-7000 Camera
Application Start
At application start, the recording starts on the first memory block.
Configuration Parameter Values
• Port = Ethernet
• Protocol = UDP
• The PGMSpeed parameter value 1000 is not available.
• Last Cue values (when Cues is Off): 50, 100, 200, 400, 800, 1600
Key Behavior
• PLAY: this key initiates a replay from the first available frame on the current memory
block.
• TAKE: this key is operational in ARM mode.
• RECORD: the remote beeps if the CAM key refers to an empty block.
• RECORD: pressing this key while the current block is recording clears all memory
blocks and starts recording on the first one.
• CLEAR: press this key to delete the current memory block data.
• Last Cue: If no cue points have been defined, pressing this key will stop the
recording and go back to the first recorded frame of the current memory block.