EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 187)

Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
Issue
11.01.D
177
17.1.3 Split MIX
This mode works similar to the H and V Split modes, except that there is no position
adjustment since both pictures are shown full frame.
The
D key allows the operator to adjust the mix percentage between the two sources.
Press the D key to highlight the function, then move the lever to adjust the mix level
between the two sources.
17.1.4 Auto-tracking mode
The Auto-tracking mode applies only to the Vertical Split mode, and allows to adjust the
horizontal position of a sequence to make sure it is as close as possible to the centre of
the left/right part of the screen.
To use the Auto-tracking, the first step is to track the object that must be kept in the
centre of the frame. Using the Target Track mode the keyframes are marked to determine
the path of the object. Refer to the Chapter 15 ‘Target Mode’, on page 163 for more
details.
When the tracking is completed in the desired clips, enter the Split Screen mode and
recall these clips on the left and right side of the screen. If keyframes have been marked
inside selected clips, the word “TRACKED” will appear on the corresponding side of the
output monitor. At playback, the picture will be shifted horizontally to keep the tracked
object in the centre of its frame.
To disable temporarily the auto-tracking without leaving the Split Screen mode, press
CLEAR+LEFT (disables Auto-tracking on left side) or CLEAR+RIGHT (disables Auto-
tracking on right side).
PGM1 CAM A *PGM2* CAM B
Aud.Met. PgmSpd Sort->TC PostRoll
Sw to IN Search Pref
P.1 B.1 Clips: LOCAL Records: LOCAL
PL 11: <
Msg:
SplitMix Swap Sync
Left Right L & R 050-050%