EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 202)

Issue
11.01.D
Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
192
Cue points management
• When a new ARM/REC command is issued on a block, all its cue points are cleared.
• If the Last Cue command cannot access the desired TC-pre-roll, the player remains
on the current cue point.
• If the Last Cue command refers to a TC that does not exist anymore, the player
jumps to the beginning of the current memory block.
• Cue points can not be marked when working on several memory blocks.
18.5.4 Vision Research Camera
Application Start
At application start, the recording does not start automatically.
Configuration Parameter Values
• Port = RS422 & Protocol = ASCII
• Or Port = Ethernet & Protocol = TCP
• The PGMSpeed parameter value 1000 is available.
• Last Cue values (when Cues is Off): 50, 100, 200, 300, 400, 600, 800, 1000
Key Behavior
• PLAY: this key initiates a replay from the first available frame on the current memory
block.
• TAKE: this key is operational in any mode.
• RECORD: the remote beeps if the CAM key refers to an empty block.
• RECORD: pressing this key while the current block is recording clears all memory
blocks and starts recording on the first one.
• CLEAR: press this key to delete the current memory block data.
• Last Cue: If no cue points have been defined, pressing this key will stop the
recording and go back to the first recorded frame of the current memory block.
Cue points management
• When a new ARM/REC command is issued on a block, all its cue points are cleared.
• If the Last Cue command cannot access the desired TC-pre-roll, the player remains
on the current cue point.