EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 157)

Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
Issue
11.01.D
147
Video Audio 1 Audio 2 Edit
The user can press the D key to access the Timeline Edit mode, or press the PLST key.
12.6 Editing Operations
The timeline editing operations on the remote require marking IN and OUT points on the
recorder before performing the extend or insert actions. These IN and OUT points can be
marked anywhere on the timeline as in the Replace mode since the timeline is equivalent
to a record train.
12.6.1 Extend Overwrite
The Extend feature in Multicam consists in extending the length of a timeline element by
extending the IN or OUT points of a clip as explained below, as long as the material is
available.
If the required material is not available, the Remote Panel will beep. The Extend is always
performed in Overwrite mode, which means that the material ‘covered’ by the Extend is
deleted from the timeline.
Extend From IN
This editing action shifts the OUT point of the timeline element which includes the Mark
IN to the defined Mark OUT. The following schema shows an example with only the video
track selected.
Original Timeline
Extend from IN
111A 111B 146A 184C
111A 111B 146A 184C
111A 111B 146A 184C
V
A1
A2
111A 111B 184C
111A 111B 146A 184C
111A 111B 146A 184C
V
A1
A2
IN OUT