Pgmspd/varmax, Sw to in, Pref – EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual User Manual
Page 38: Aud.met, Postroll

Issue
11.01.D
Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
28
PgmSpd/VarMax
Pressing
PgmSpd once enables the Program Speed mode and highlights this function on
the LCD. Pressing the key once more enables the Var Max mode and highlights this
function on the LCD. The
PLAY key is flashing red while either of these modes is
enabled.
•
Program Speed mode: In this mode, only two speed values are available from the
lever: 0% when the lever is in the lower position, or the speed defined in the
Operational Setup menu (p.9.1 F3) for any other position of the lever.
•
Var Max mode: the speed range defined by the lever is limited between 0% and the
speed value defined in the
Operational Setup menu (p.9.1 F3).
Sw To In
When this function is enabled (highlighted), a camera change will cause a jump to the
corresponding IN point if existing. It will switch in Sync if no IN point exists for the current
element, or if SW to IN is OFF.
Pref
Selecting this function enables the Preference mode (see section 5.6 ‘Preference Mode
(PREF)’ for more details).
Aud.Met.
This option enables/disables the display of audio meters for all channels using the OSD
of the output monitors.
PostRoll
When the Post-Roll mode is enabled, that function is highlighted on the LCD and a “P”
appears on the OSD of the output monitors.