EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 143)

Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
Issue
11.01.D
133
11.17 Swap Audio Tracks
11.17.1 Introduction
The swap audio tracks mode allows swapping audio tracks between two points in a
playlist.
In four-track mode, the “auto” mode replaces audio tracks 1&2 by audio tracks 3&4 in four
audio mode. It replaces audio track 1 by audio track 2 in stereo mode.
The manual mode lets you choose which tracks to replace.
Note
In 8- and 16-track modes, you only have access to the manual mode.
11.17.2 How to Enable the Audio Swap Mode
To enable the Audio Swap mode, proceed as follows:
1. Enter the
Setup menu.
2. Select the Swap audio tracks parameter value in the Operational Setup menu
(p.3.2 F4).
3. Choose a value between “Auto” and “Manual”.
Please note that the Advanced audio editing parameter has to be enabled in the
Operational Setup menu (p.3.2 F2). This option requires a specific license code. If
that code is not installed on the server, this option cannot be turned on.
11.17.3 How to Perform a Swap Audio Track in
Auto Mode
To perform a swap audio track in Auto mode, proceed as follows:
1. In Playlist Edit mode, select the Video Base mode (V Base). The LCD screen will now
display additional function:
2. Press the SWAP function (SHIFT+D).
PL11 LSM01 Paola LOC TDUR=00:00:02:22
111A/04 Clipname0123 00:00:29 Unk W00:10
112B Clipname4567 00:53:29 Unk W00:10
112B/02 Clipname8910 00:53:29 Unk W00:10
V Base A Base Swap
A Advanc A Delay A FX DUR A Split