EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 147)

Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
Issue
11.01.D
137
11.17.5 Deleting Swap Points
When the operator is on a swap point, pressing CLEAR+IN/OUT deletes the current swap
point. All swap points for that timecode are deleted.
When the operator is not on a swap point, pressing CLEAR+IN/OUT brings up a
confirmation message to delete all swap points for the current clip.
11.17.6 Navigating Among Swap Points
When the operator is in Swap mode, the previous swap point can be reached by pressing
the Go to In button on the Remote. The next swap point is reached by pressing the Go to
Out button. The function works in loop mode.
11.18 Replace Function
11.18.1 Introduction
The purpose of the Replace function is to automate a routine used by operators to create
effects in a playlist: the operator would loop a section or an entire playlist back to
themselves and, during the playback, add some effects externally (graphic insertion for
instance) or internally (changing the speed).
While the operator would play the playlist back, and insert the requested effects, the
playback result would be re-injected into the playlist from a predefined IN frame. The OUT
point of the replaced section would be predefined or manually defined in the record
process.
Note
The Replace function is not allowed on playlists containing growing clips.
11.18.2 Entering the Replace Function
A secondary menu with the Replace function has been added to the Playlist Edit mode.
Pressing MENU in Playlist Edit mode brings up the following menu:
Clr Unav. OtherAng
Replace MakeLoc Redo Undo
Select Replace in this secondary menu to enter the Replace function.