EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 135)

Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
Issue
11.01.D
125
11.16.6 Default Mode for Extending a Transition
Introduction
Whenever you make a video or audio split, the transition originally set is changed, which
means extended on either or both sides of the transition boundaries. In the Operational
Setup menu, use the Extend split transition parameter (p.3.2 F3) to set the default
mode for extending transition effects, this means you specify where the effect is
extended.
Transition Modes
The following table summarizes the various transition modes:
Criteria Description
Center (on) Cut The transition is extended equally in both directions. This is
the default value.
End (on) Cut The transition is extended to the left, so that the end of the
transition is not changed.
Start (on) Cut The transition is extended to the right, so that the start of the
transition is not changed.
Ask Asks the operator to choose one of the 3 options above each
time he edits a transition.
Possible Cases
You can build different types of playlists depending on:
• the transition mode in video or audio split
• the transition duration
The following schemas show, for each transition mode, a playlist with:
• the same video and audio transitions (no audio or video split)
on playlists 10, 13 and 16.
• an extended audio transition (V Base edit)
on playlists 11, 14 and 17.
• an extended video transition (A Base edit)
on playlists 12, 15 and 18.