Video delay, Ideo, Elay – EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual User Manual
Page 46

Issue
11.01.D
Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
36
8. Video Delay
When the Multicam software has been configured with a base configuration = Video
Delay in the
Channel Parameters menu, the Delay Screen will appear automatically
when the application is started. In this case, all play channels will be available from the
Delay screen.
If Multicam is running a base configuration different than Video Delay, this screen can be
called manually from the Clip screen, Playlist Screen or Network Screen by pressing
SHIFT + F7 on the keyboard. In this case, only the play channels assigned to user #1 (i.e.
the 1
st
EVS Remote Panel if the base configuration is LSM or maXS, or the 1
st
protocol if
the base configuration is in slave mode).
For each play channel, the operator can adjust:
•
the video and audio source (camera angle, and source server if several units are
connected on an SDTI network);
•
the desired delay in hh:mm:ss:fr.
For each play channel, the operator can view:
•
the actual delay in hh:mm:ss:fr;
•
the timecode of the on-air picture
•
the timecode of the incoming picture on the associated record channel;
•
the status of the associated record channel (Recording / Idle)