2 clip availability on disks, 2 using the evs remote panel, 1 how to create a clip – EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual User Manual
Page 49: Clip availability on disks, How to create a clip

Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
Issue
11.01.D
39
•
The guardband beyond the Short OUT point is created with the material
available when the operator saves the clip by pressing the selected
F_ key.
Therefore, this guardband can sometimes be shorter than the value defined
in the Setup menu.
9.1.2 Clip Availability on Disks
Various clip types can be distinguished depending on whether they are available on the
disks or not. Depending on the clip availability on disks, you can perform specific actions
on the given clip or not.
Clip on disk
Clips which are protected on disks, and which have Short IN
and Short OUT points present on disks.
All the material is available on the disk.
Growing clip
Clips which are protected on disks, and which have a Short IN
point, and possibly Short OUT point defined on disks.
Since the record process is still undergoing, some of the
material is already on the disk but not all of it.
Reserved clip
Clips for which the position has been reserved on the SDTI
database but for which there is no Short IN and Short OUT
points, nor any protect present on disks.
9.2 Using the EVS Remote Panel
9.2.1 How to Create a Clip
To define a clip, proceed as follows:
1. Select the LIVE mode.
2. Define your Short IN point using the jog dial. Press the
IN key to mark your Short IN
point of the clip.
3. Search for the desired Short OUT point and then press the
OUT key to mark it.
A clip can be created with only IN point or only OUT point. The system will automatically
define the clip duration according to the default duration defined in the Setup menu.
Note
You can mark an IN or OUT point on a paused record train and go back to live
without losing the point marked by pressing SHIFT+