EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 201)

Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
Issue
11.01.D
191
• If the Last Cue command refers to a TC that does not exist anymore, the player
remains on the current frame.
• Cue points can be marked across several blocks but the recall is limited to the
currently selected block.
Example:
o While recording on memory block 1, mark cue points 1, 2, and 3 on memory
block 1.
o Press TAKE to start recording on block 2 and mark cue points 1, 2, and 3.
o Press TAKE and select memory block 2. The Last Cue command scrolls through
the cue points of block 2.
o To go through cue points of another block, select that block first then press Last
Cue.
• On OSD, the first information, displayed in white, refers to the cue points on the
playing block while the second information, displayed in red, refers to the recording
block.
18.5.3 Photron Camera
Application Start
At application start, this camera is in ARM mode and the recording starts on the first
memory block.
Configuration Parameter Values
• Port = RS422
• Protocol = Sony 9-PIN
• The PGMSpeed parameter value 1000 is available.
Key Behavior
• PLAY: this key initiates a replay from the first available frame on the current memory
block.
• TAKE: this key is operational in ARM mode.
• RECORD: the remote does not beep if the CAM key refers to an empty block.
• RECORD: pressing this key while the current block is recording does not send any
command to the camera.
• CLEAR: this key has no effect.
• Last Cue: If no cue points have been defined, pressing this key will stop the
recording and go back to the first recorded frame of the current memory block.