EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 111)

Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
Issue
11.01.D
101
11.9 Overview of Editing Functions in
Playlist Edit Mode
The following section presents the various editing functions available from the main and
secondary Playlist Edit Mode.
11.9.1 Main Menu in Playlist Edit Mode
Introduction
The main menu in the Playlist Edit mode is available when you select the location of the
requested playlist, and press PLST on the Remote Panel:
Effect Edit All
Insert Speed FX Dur Delete
In the Playlist Edit mode, the first frame of the playlist element loaded (highlighted on the
Remote Panel LCD display) can be seen on the PGM. To change any of the options on a
clip, simply browse to the requested clip, then select a function from the menu displayed
above and use the control lever to adjust to the desired value (when applicable).
Edit All
If you want to edit all clips of the playlist at the same time, select Edit All (SHIFT+D)
before you perform the requested editing action with one of the following playlist
commands: Speed, Effect, FX Dur.
Insert
The Insert function (A key) allows the operator to insert a clip into the playlist. The same
operation can be achieved using the TAKE key.
See also the section 11.10.4 ‘How to Insert Clips into a Playlist’, on page 105.
Speed
The Speed function (B key) allows defining the speed at which one or all clips of a playlist
will be played. Select the playback speed of the clip with the lever, then press ENTER to
validate. Values are ‘Unknown’ and from 0 to 100%.
Operators have access to the secondary lever control like when clips are replayed. While
editing the speed of a clip, pressing SHIFT+Lever on the Remote allows to access the
secondary lever speed defined in the menu.