EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 22)

Issue
11.01.D
Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
12
Function Keys in the Main Menu
Select the corresponding Function key ( F_ key), and then press ENTER to validate the
selection.
Function Key Use
F1 to F4 If desired, the Multicam system can be run using 1, 2, 3 or 4 EVS
Remote Panels. Depending on the number of play channels
available in the current configuration, 1-, 2-, 3- or 4- Remote modes
will be available from the main menu.
F1: 1 Remote One Remote Panel is used in the configuration
F2: 2 Remotes Two Remote Panels are used in the configuration.
If 4 play channels are available, when selecting the 2 Remotes
mode, the operator can choose between two configurations:
• 2 play channels for each remote:
In this configuration, each Remote Panel can select PGM+PRV or
2PGM mode. Each Remote Panel can manage video transitions
(cut, mix, wipe) in PGM+PRV and playlist modes.
• 3 play channels for the 1 st remote and 1 play channel for the
second remote.
In this configuration, the 1
st remote can select PGM+PRV or
3PGM mode and can manage video transitions. The 2 nd remote is
forced to 1PGM mode and can only handle cut transitions.
F3: 3 Remotes Three Remote Panels are used in the configuration.
F4: 4 Remotes Four Remote Panels are used in the configuration.
F5: Char. On/Off Enables or disables the on-screen display (Timecode, Clip ID…) on
the output monitors.
F6: Exit Exits the Multicam software and returns to the EVS Menu.
F7: Clear all clips Clears all clips. All clips will be lost. A confirmation of this command
is required.
For more information to this action, refer to the section 9.2.6
‘Clearing Clips’, on page 43.
Note: This command is not similar to the Clear Video Disks from
the Maintenance menu. If you wish to refresh completely the server,
i.e. to clear all clips including the protected ones, you need to use
Clear Video Disks rather than Clear all clips.
F8: Stop Record Stops the record. The REC key will go off and the F8 function key is
now used to restart the record.