EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 192)

Issue
11.01.D
Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
182
Last Cue
This key corresponds to the ‘search’ command on hypermotion cameras.
If cue points have been defined, press Last Cue to go to the previous cue point of the
current memory block.
Note
If no cue points have been defined, the
Last Cue button behavior depends on
the camera model.
RECORD
This key corresponds to the ‘ARM’ or ‘REC’ commands on hypermotion cameras.
When you press RECORD for the first time, all the A/V material recorded in the memory
block(s) of the camera is deleted.
Please refer to the camera models specific features at the end of this chapter for more
information about the behavior of your camera when pressing the RECORD key on a
recording memory block.
TAKE
This key corresponds to the ‘Trig/Stop Rec’ command on hypermotion cameras.
With a single-block memory or when the last block is reached, press TAKE to stop the
recording.
With a multiple-block memory, press
TAKE to stop the record on the current block and
automatically start the record on the first free block, if available.
Lever
There is no corresponding command on hypermotion cameras.
Press the
Lever key to shift to the secondary lever range (defined in the 2ndLever
parameter in the hypermotion secondary menu) for material played out using the
hypermotion feature.
CAM Keys
Press a CAM key corresponding to a recorded block to load the last recorded frame of
the selected block in play mode.
If you press a CAM key corresponding to an empty block, the remote beeps.
Note
Depending on the camera model, these keys may expose additional behavior.