EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 14)

Issue
11.01.D
Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
4
1.2 Configuration on LSM Remote
Before you start using the Multicam application in Multicam LSM mode, you need to
ensure that the parameters are properly defined in the Setup menu of the Remote Panel,
and in the Setup Configuration module of the Multicam application. The new
parameters are saved as soon as they are modified.
Important
Prior to using Multicam, the operator should enter the Setup menu and set all
necessary parameters. If clips are stored with certain parameters and the
operator wishes to change them afterwards, those clips and playlists will not
change. It is thus important to set these parameters first.
The Multicam Configuration manual includes a detailed description of all settings which
can be defined on the Remote Panel.