beautypg.com

Results, Examples, 10 how to shorten a clip – EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual User Manual

Page 61: How to shorten a clip

background image

Multicam - Version 11.01 – Operating Manual

EVS Broadcast Equipment SA – November 2012

Issue

11.01.D

51

timecode type (USER) or whatever TC type (LTC+USER).
Press several times the

C soft key to select the requested value.

7. Press the

D key to specify whether to search only for local clips (Srch Loc) or on the

entire XNet Network (Srch Net).
Press several times the

D key to select the requested value.

8. Press

ENTER to launch the search.

Results

If matching clips are found, the Remote Panel will automatically be in Browse mode (the

BROWSE key is red), allowing the operator to quickly view the frame of each clip

corresponding to the requested timecode by rotating the jog dial.
To be able to jog inside a clip, disable the Browse mode by pressing on the

BROWSE

key and move the jog dial. To return to the Browse mode inside the search results, press

the

BROWSE key again.

Search results are reset when going by to LIVE mode, or when a new search is

performed.

Examples

You have loaded the picture of an interesting event, and you want to see all clips that

contain that same event. Call the Sort ->TC function, select the network/local search

option and launch the search. Move the jog dial and you will see the same event on

the same timecode from all available camera angles that have been clipped.

You know the timecode of a particular event and you want to see all clips containing

that event. Call the Sort ->TC function, edit the timecode to the desired value, select

the network/local search option and press

ENTER: you will obtain the same result as

above if the timecode belongs to the same type as the one previously mentioned.

9.2.10 How to Shorten a Clip

To shorten a clip, proceed as follows:
1. Recall the desired clip by pressing the corresponding

F_ key.

2. Move the jog dial to browse the clip and reach to the desired Short IN point.
3. Press the

IN key to mark a new Short IN point. The new Short IN point is instantly

saved.

4. Move the jog dial to reach the desired Short OUT point.
5. Press the

OUT key to mark a new Short OUT point. The new Short OUT point is

instantly saved.

Move the lever or press the PLAY key to play the clip. The replay will stop at the new

Short OUT point (or after the Short OUT point if the Post-Roll mode is enabled).

This manual is related to the following products: