EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 180)

Issue
11.01.D
Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
170
16.1.4 Overview on the Offside Line Commands
Main Menu
The offside line menu displays as follows and the Mark key is blinking:
TRANSP OSD QUIT
SHIFT SIDE REDO UNDO
The following table summarizes the various available commands:
OSD Command Meaning
SHIFT/TILT (A) Moves the line horizontally (Shift) or around its pivot point (tilt).
SIDE (B) Changes the shaded area from side.
REDO (C) Redoes the last undone action.
You can redo the last 10 undone actions.
UNDO (D) Undoes the last action.
You can undo the last 10 actions.
TRANSP (SHIFT+B) Allows the user to change the transparency level with the jog
or lever. Press Enter to validate the action.
OSD (SHIFT+C) Allows the user to hide or display again the information on the
OSD.
QUIT (SHIFT+D) Exits the offside line mode.
Secondary Menu
Pressing the MENU key opens a secondary menu that allows you to specify the following
offside line settings:
Setting Description
Pause duration Time (in frames) between the train or clip is paused and the
offside line mark is displayed.
Fade in/out duration Duration (in frames) of the fading effect on the IN and OUT
points of the offside sequence.
Preroll duration Preroll (in seconds) before the offside sequence automatically
defined as a cue when the sequence is saved.