Cue points management – EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual User Manual
Page 204
Issue
11.01.D
Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
194
Cue points management
•
NOTE: the cue points are only operational when all memory blocks have been
recorded once.
•
When a new ARM/REC command is issued on a block, all its cue points are cleared.
•
If the
Last Cue command cannot access the desired TC-pre-roll, the player remains
on the current cue point.
•
If the
Last Cue command refers to a TC that does not exist anymore, the key beeps
but the OSD still displays the number of the cue that you wanted to go to.
•
Cue points can be marked across several blocks but the recall is limited to the
currently selected block.
Example:
o While recording on memory block 1, mark cue points 1, 2, and 3 on memory
block 1.
o Press TAKE to start recording on block 2 and mark cue points 1, 2, and 3.
o Press TAKE and select memory block 2. The Last Cue command scrolls through
the cue points of block 2.
o To go through cue points of another block, select that block first then press Last
Cue.
•
On OSD, the first information, displayed in white, refers to the cue points on the
playing block while the second information, displayed in red, refers to the recording
block.