Sort->tc, Set tc, Name – EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual User Manual
Page 59: Search, Post-roll, On ‘sort->tc, E 49

Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
Issue
11.01.D
49
Sort->TC
The Sort->TC function allows the operator to search the database for all clips or trains
containing a specific timecode. Press SHIFT+C again in Set TC mode to call it.
When calling this function, the timecode of the current picture is used as a default
selection. The operator can immediately perform the search or he can edit that timecode
before starting the search.
For more information on how to search for clips by timecode, refer to the section 9.2.9
‘How to Search for Clips by Timecode’, on page 50.
Set TC
The Set TC function is only available in SHIFT+B on the Sort->TC menu. It allows the
operator to restripe the timecode of a clip. This function is explained in details in the
section 9.3.12 ‘How to Restripe the Timecode of the Current Clip’, on page 62.
Depending on the mode selected with the
D key (CLIP/CAM), the new timecode value is
assigned only to the camera angle of the clip loaded on the primary channel (CAM
mode), or to all camera angles of the clip (CLIP mode).
Name
The Name function is only available if a keyword file is selected in the Setup menu. It is
used to name a clip based on available keywords. Refer to the chapter 10 ‘Keyword
Management’, on page 72 for more details. When the Name function is selected, pressing
SHIFT+C again will call the Search function.
Search
The Search function is “hidden” behind the Name function. Press SHIFT+C again in
Name mode to call it. It allows the operator to search the database for clips based on
keywords and ranking. Please refer to Chapter 10 ‘Keyword Management’, on page 72
for details.
Post-Roll
This function enables/disables the Post-Roll mode. This mode is explained in details in
the section ‘PostRoll’, on page 28.