EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 58)

Issue
11.01.D
Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
48
For more information about the Push settings, refer to the Operational Setup menu on
the Remote Panel, page 7.1.
In both cases, a message appears for a few seconds on the LCD to confirm that the clip
is being pushed and indicate the clip location where it will be stored on the receiving
machine.
If the Receive Page(s) defined on the destination machine is (are) full, the operator who
tries pushing the clip is notified. While this message is being displayed, the operator can
press the MENU key at any time to return to the normal menu. Depending on the
CAM/CLIP mode selected by the D key, only the camera angles loaded on the controlled
channels are pushed (CAM mode), or all camera angles of the clip are pushed at once
(CLIP mode).
>Archive
The Archive function allows the operator to flag a clip to place it in the archive queue of
the XFile 1 defined in the Operational Setup menu (p.7.1 F3).
This function is blinking when the clip is flagged for archiving, but has not yet been
archived. It is permanently highlighted when the archiving of the clip is completed.
Depending on the mode selected with the
D key (CLIP/CAM), the >ARCHIVE flag is
assigned only to the camera angles of the clip loaded on the controlled channels (CAM
mode), or to all camera angles of the clip (CLIP mode).
Aux Clip
This function allows assigning a clip as auxiliary audio clip to the current playlist. Press
CLEAR+Aux Clip (CLEAR+SHIFT+B) to remove the current auxiliary clip. Refer to the
chapter 11 ‘Playlist Management’, on page 89 for more details.
Ranking (***)
The Ranking function allows assigning a ranking to the current clip. Pressing several
times this key will scroll through the different values: 0 (***, not highlighted).
Depending on the mode selected with the
D key (CLIP/CAM), this ranking is assigned
only to the camera angles of the clip loaded on the controlled channels (CAM mode), or
to all camera angles of the clip (CLIP mode).
If the
Keyword info parameter of the Operational Setup menu (p.1.1 F2) is set to “Yes”,
the ranking will appear on the OSD of the output monitors when cueing up the clip.
1 The EVS Xfile is a 2U device with 2 removable hard drives, that can be connected to the XNet
SDTI network. Clips can be archived to/restored from the removable media.