EVS XT3 MulticamLSM Version 11.01 - November 2012 Operation Manual - Manual (Page 146)

Issue
11.01.D
Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
136
LOOP
12:23:45:13 00:07:13 100
112B/04 ClipName 999/999
11.17.4 How to Perform a Swap Audio Track in
Manual Mode
If the Manual mode is selected for the Swap audio tracks parameter value in the
Operational Setup menu (p.3.2 F4), the swap operates in a similar way but asks the
operator which track to swap when setting the swap points.
Step 1
First the operator is being asked to select the original track:
• In 2-Track mode: you select between the tracks 1,2 or MENU to cancel.
• In 4-Track mode: you select among the tracks 1 to 4, or MENU to cancel.
• In 8-Track mode: you select among the tracks 1 to 8, or MENU to cancel.
• In 16-Track mode: you select among the tracks 1 to 16, or MENU to cancel. The
tracks 1-8 are displayed on a 1 st page and the tracks 9-16 are available via F10 on a
2 nd page.
The function keys are used to select the track to change.
Step 2
When the choice is made, the operator selects by which track the selected one has to be
replaced:
• In 2-Track mode: you select the new track between 1, 2 or 0.
• In 4-Track mode: you select the new track among 1 to 4, or 0
• In 8-Track mode: you select the new track among 1 to 8, or 0
• In 16-Track mode: you select the new track among 1 to 16, or 0. The tracks 1-8 are
displayed on a 1 st page and the tracks 9-16 are available via F10 on a 2 nd page.
Several swap points can be set on the same timecode (e.g.: 1 -> 3, 2 -> 4).
Note
Selecting
track 0 will mute the output until the next swap point or the end of
the clip.