RIGOL DP832A - Manual (Page 85)

Chapter 2 Command System RIGOL
DP800 Programming Guide 2-61
:OUTPut:OVP:VALue
Syntax :OUTPut:OVP:VALue [CH1|CH2|CH3,]{|MINimum|MAXimum}
:OUTPut:OVP:VALue? {CH1|CH2|CH3}[,MINimum|MAXimum]
:OUTPut:OVP:VALue? [MINimum|MAXimum]
Description Set the overvoltage protection (OVP) value of the specified channel.
Query the overvoltage protection (OVP) value of the specified channel.
Query the overvoltage protection (OVP) value of the current channel.
Parameter Name Type Range Default
[CH1|CH2|CH3] Discrete CH1|CH2|CH3 None
Real Refer to Table 2-2
{CH1|CH2|CH3} Discrete CH1|CH2|CH3 None
Explanation  When the overvoltage protection function is enabled, the output will turn off
automatically when the output voltage exceeds the overvoltage protection
value currently set. You can send the :OUTPut:OVP:ALAR?
or :OUTPut:OVP:QUES? command to query whether overvoltage protection
occurred on the specified channel currently.
 When [CH1|CH2|CH3] is omitted, the system sets or queries the OVP value of
the current channel.
 You can also send the [:SOURce[]]:VOLTage:PROTection[:LEVel]
command to set the OVP value of the specified channel.
Return Format The query returns the overvoltage protection value, for example, 8.800.
Example :OUTP:OVP:VAL CH1,8.8 /*Set the overvoltage protection value of CH1 to 8.8V*/
:OUTP:OVP:VAL? CH1 /*Query the overvoltage protection value of CH1 and
the query returns 8.800*/
Related
Commands
:OUTPut:OVP:ALAR?
:OUTPut:OVP:QUES?
:OUTPut:OVP[:STATe]
[:SOURce[]]:VOLTage:PROTection[:LEVel]